can i dress a diamond saw blade with a brick

When diamond saw blades encounter difficulties in cutting, reduced sharpness, and decreased self sharpness during use, we usually use materials with higher abrasive properties for dressing or trimming. For example, refractory bricks, dressing stones, dressing concrete, etc. But when we are dressing the saw blade, we must analyze the specific problem and not blindly dress it.

 

 

Firstly, we need to understand under what circumstances the saw blade needs to be dressed?
There are usually two situations:

• Body wrapping: The saw blade cuts soft and tough materials (such as asphalt, cork, and concrete containing steel bars), and the debris worn off will wrap around the diamond particles, resulting in a decrease in cutting efficiency. At this point, the saw blade itself was not worn out, it was just "stuck".
• True dullness: Cutting very hard or abrasive materials (such as granite, refractory bricks, hard concrete) causes premature wear or detachment of diamond particles, while the metal matrix does not show corresponding wear, unable to expose new sharp particles.

 

 

Secondly, we need to choose suitable materials for dressing
Use specialized sharpening stones or sharpening blocks. These products are made of uniform and moderately abrasive materials (such as sandstone, specific concrete blocks), and their hardness is designed to effectively remove a small amount of metal matrix without damaging the diamond.

 

Secondary material selection: If there is no sharpening stone, you can find a clean and highly abrasive concrete block or refractory brick. Note that it is refractory bricks rather than ordinary red bricks. Refractory bricks have a more uniform material, higher hardness, and relatively better effect.

 

In practice, experienced technical engineers, workers, and operators usually use refractory bricks or fine sand rough soft concrete for dressing.

 

Finally, how to dressing the saw blade?
Operation Method:

• Install the saw blade onto the cutting machine or table saw to ensure a secure fixation.
• Take good safety precautions: wear goggles and gloves.
• Let the saw blade slowly and gently touch the sharpening stone or concrete block while idling, for a few seconds each time.
• Repeat 2-3 times, during which water can be sprayed for cooling.
• The purpose is to use abrasives to grind off a thin layer on the surface of the tire body, exposing new diamond particles

 

In short, try not to use red bricks to dress diamond saw blades. Invest in a specialized sharpening stone, or use refractory bricks or fine sand soft concrete blocks for dressing. At the same time, it must be carried out under the guidance of professionals. Of course, replacing the saw blade is a wiser choice in terms of safety and economic benefits.

 

Choosing a suitable and high-quality saw blade will save you a lot of trouble. The saw blades produced by Huice Company have stable performance, high cost-effectiveness, good self sharpening, and do not require any dress. We not only provide high-quality diamond saw blades, but also offer you professional technical solutions and guidance. Let you use the saw blade with peace of mind.

Contact now