Have To Know The Saw Blade Tips

The engineer for the diamond saw blade cutting stone work incisive summary, have to know the saw blade tips:

1. The block shall not be less than 0.5m3, and placed securely, the bottom surface should be lined with square wood, plugged firmly, and the block should be located in the symmetrical position of the workbench to ensure the stability of the workbench and the block, and there should be no shaking and trembling.

2. Test cutting can be carried out after the saw blade idling is stable, and the saw blade is not allowed to start when the saw blade is in contact with the block, and the saw blade rotation is not allowed to stop during cutting, and it can be stopped after exiting the saw mouth.

3. If the block is found to be shaking during cutting, the cutting should be stopped immediately, and the work can continue to work only after the block is fixed firmly.

4. Idling: Especially when the new substrate is used for the first time, it needs to be idled for about 30 minutes, and it is necessary to idle with water in the summer high temperature season, which is aimed at further clarifying the influence of welding the cutter head on the substrate, and enhancing the memory of the internal quality of the saw blade in the high-speed rotation state.

5. Adjust the stroke switch according to the length, width and height of the block, so that the saw blade lifting and the stroke of the material truck are within a reliable and effective range. Before sawing, the blade blade should leave the block to a height of 10~20mm. After sawing, the saw mouth should be left 20-40mm from the bottom of the block, and before the saw blade left and right run, the saw blade should all exit the block saw mouth, and the distance should not be less than 150-200mm to prevent the saw blade from hitting the block.